Gaswinkel HP24 Owner's Manual
                   | |
Page 15 / 19standards. Ask your dealer for a recommended pellet type.2. Please keep the door closed and sealed at all times during burning. This is for good effectand prevents hot ash flying out. As soon as the door is opened the auger stops feedingpellets and the appliance will go into shut-down mode.3. The good burning features are a-bright yellow flame of the pellets burning with a littlejumping in the gratebar (combustion retort). Pellets should not pile up and there should beno smoke. If the combustion pattern changes to a little dark glow with a lazy flame and smokeappearing from the venting terminal, the convection blower to increase the air input needsspeeding up. This should only be carried out by a suitably qualified engineer.4. For reducing the heat output, it is better to reduce the pellet feed. At the same time thespeeds of convection blower and exhaust blower should be turned down until the best effect isattained. This should only be carried out by a suitably qualified engineer.2. Venting pipe and air input pipe should keep unblocked.Safety instructions1. The power jack must be grounded (earthed).2. No combustion or explosive materials around the stove when it is operating.3. When installing this unit on a combustible floor (for example linoleum, hardwood flooring)a non-combustible hearth pad (15mm thickness), with sufficient load-bearing capacitymust be under the unit.4. Do not open the stove door when the stove is operating.5. Do not touch the surface when the stove is operating. The high temperature of the stoveglass door and venting pipe will cause burns.6. Use only the auto-ignition device to light the appliance. For safety, do not use gasoline orother combustion or explosive materials to ignite the appliance7. After a prolonged shut down period ensure that all passageways for supply air andexhaust gases are free from blockage.8. In the event of a chimney fire :-Raise the alarm to let others in the house know.Call the Fire Brigade.Reduce the appliance-burning rate by closing all air controls.Move furniture and rugs away from the fireplace and remove any nearby ornaments.Place a fireguard or spark guard in front of the stove.Feel the chimney breast for signs of excessive heat. If the wall is becoming hot,move furniture away.Ensure that the Fire Brigade can gain access to your roof space in order to check forsigns of fire spread.MaintenanceNO unauthorised modification of this appliance should be carried out.This appliance requires regular maintenance by a competent engineer. |
manualsdatabase
Your AI-powered manual search engine