21Programming the remote controlwww.gateway.comTeaching the remote control new functionsThe remote control can learn up to 25 additional functions from thecomponent’s original remote control.Example:Your DVD player remote control has a scan function that you use frequently.There is not a scan button on the remote control. You can assign a button anduse the DVD remote to teach the remote control the scan function.To teach the remote control a new function:1 Press and hold SETUP on the remote control until the LED flashes twice.2 Press 9 7 5. The LED flashes twice.3 Press the component button that you want (DVD) once.4 Press the button on the plasma TV remote control that you are assigningthe new function to. The LED flashes quickly while it is waiting to receivethe signal from the teaching remote control.5 Hold the teaching remote control approximately 1-inch (2.54 cm) from theplasma TV remote control making sure that the infrared ports are lined up,then press the button on the teaching remote control that you want theremote control to learn. The LED flashes twice.6 Press SETUP to exit learning mode.Important Make sure that you have already programmed the remotecontrol for the component. See “Programming the remotecontrol” on page 7.Make sure the area lighting is not too bright or it willinterfere with the learning process.