Programming instructions4.26 QS4 Technical Reference ManualSetting up a ZoneBefore you begin Before you begin, you should complete a Zone ProgrammingWorksheet (Figure 4-9) for each Zone. Keep a copy for yourrecords. You will also need to refer to the Output Groupprogramming worksheets.To set up a Zone:1. On the control panel, press Menu.2. Choose Login then enter the password required for Level 4access.3. Choose Program > Configure > Zone.4. To program a new Zone, choose Add, and then choose azone type (Alarm, Supervisory, or Monitor).— or —Choose Edit, select an existing zone from the pick list, andthen press Enter.Configure the Zone 1. Choose Message, scan in the message text, and thenpress Enter.2. Choose Members, then for each device that comprises theZone:Choose Device Address, then enter the member's devicenumber from the worksheet— or —Choose Enter Serial#, scan in or enter the member's serialnumber.3. Choose Review to verify which devices you added to theZone. If you added any devices in error, delete them.4. Choose Output Group > Add, then select the Output groupfrom the pick list that contains the responses you wantactivated, and then press Enter.Repeat for each Output group you want to add.5. Choose Review to verify which Output groups you added tothe Zone. If you added any Output groups in error, removethem.6 For coded systems, choose Coding, and then enter theZone Code.Technical Manuals Online! - http://www.tech-man.com