Gecko in.xm2 Quick Start Card

Also see for in.xm2: Quick start card Quick start card

Gecko in.xm2 Quick Start Card Manual pdf 1 page image

Quick Start Cardin.xm2™For 240 VAC (*3 wires)*If connected to a3 wire system (withoutneutral), all 120 VACcomponents will notwork.For 240 VAC (4 wires)Correct wiring of theelectrical service box,GFCI, and pack terminalblock is essential. Call anelectrician if necessary.2- Connect the input cableFusesPower box display and buttonsMain powerentry connectionMain powercable input entry Mounting feetInstallation bracketsOutput connectors for in.therm™remote heating system (240 vac)Pump 1Light or CoolRaysconnector General I/O connector(IR receiver)in.keys™ main andaux. keypad connectorsCommunication connectorConnector for direct120/240 vac 5 Ampoutput (for in.play™audio, video accessoriesor in.clear™)Typically Blower(max. 5 Amp)Typically Circulation Pump(max. 5 Amp)Pump 2 Pump 31- Connect all outputs & keypadsDon't forget that the voltage is determined by the cable used (120 or 240V cable)!3- Set breakerPress Select button once to activate thebreaker setting menu. Once activated, the display shows “br” and, insuccession, the maximum current rating of the breaker.Press Change button to change setting.Press Select to confirm. You will exit menu automatically (in.xm™ will alsoreset).Selecting Breaker (Br) settingsBr values displayed bythe system correspondto 80% of the maximumamperage capacity ofthe GFCI.GFCI Br60 Amp 48 Amp50 Amp 40 Amp40 Amp 32 Amp30 Amp 24 AmpMake sure all accessories are linked to the bonding connector and connected topack. Make sure the spa pack door is closed. Turn on the breaker.Bonding lugOzone4- Select Low LevelPress and hold Select button for 5 seconds to activate low level programming.Once activated, the display shows “LL” and, in succession, the current preset low level configuration selected.Press Change button repeatedly to select the same appropriate configuration for the spa.See low level programming table.Press Select to confirm. You will exit menu automatically. The in.xm™ will then reset.You need to activate all the pumps and blower with the keypad to remove the air in the system. This step is important to do before learning.After resetting, the system starts a "learning sequence" in which each individual output is activated and its peak current displayed and saved.Selecting Low Level & learningNote: if unusual current readings e.g.: 4 to 6 amps are detected on the high speed of any pump, all pumps must be primed and the learningmode should be restarted.

/ 2

Related manuals for Gecko in.xm2