FADER REPLACEMENT:SPECIFICATIONS:1. UNSCREW THE FADER (B) SCREWS. DO NOT TOUCH INSIDESCREWS (C) CAREFULLY REMOVE OLD CROSS FADER AND UNPLUGCABLE (D)2. PLUG IN THE NEW CROSSFADER INTO CABLE (D) ANDPLACE BACK INTO MIXER.3. SCREW THE CROSS FADER TOMIXER WITH THE FADER PLATESCREWS (B)4. REPLACE THE FACE OF THEMIXER AND SCREW THE FOURSCREWS BACK IN AND REPLACE THE FADER KNOBS.INPUTS:Phono:..........................................................................3 mV, 47 KOhmLine:.........................................................................150 mV, 27 KOhmMIC 1, 2, & 3:.............................................1.5 mV, 2 K Ohm BalancedBass:..........................................................................................± 12dBHigh:...........................................................................................± 12dBOUTPUTS:Amp/Booth:.............................................................0 dB 1 V, 400 OhmMax:........................................................................20 V Peak-to-PeakRec.............................................................................150 mV, 5 KOhmZone........................................................................0 dB 1 V 400 OhmBalanced..................................................................6 dB 2 V 400 OhmGENERAL:Frequency Response:.....................................20 Hz - 20 KHz +/- 2 dBDistortion:....................................................................................0.02%S/N Ratio:.................................................................Better Than 80 dBTalkover Attenuation:..................................................................-16 dBHeadphone Impedance:...........................................................16 OhmPower Source:............................................115/230 V, 60/50 Hz, 20 WUnit Dimensions:.................................................W 19" x H 4" x D 9.1"..................................................................(482.6 x 100.6 x 231.2 mm)Weight:..................................................................... 10.34 lbs (4.7 kg)SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTIFICATIONFOR IMPROVEMENTMM-1800/2400(MM-2400) CONTROLS:ECHO SECTION:An echo effect may be applied to the PGM, or MIC 1 & MIC 2signals by switching the ECHO ASSIGN switch from MIC 1-2 on theLEFT, to OFF in the MIDDLE, to MASTER on the RIGHT & viceversa. When using ECHO, you may adjust the effect of the ECHO byusing the rotary REPEAT, DELAY, and ECHO VOLUME controls.To turn the ECHO ASSIGN OFF or lower the ECHO VOLUME.SOUND EFFECTS SECTION:Six different sound effects (APPLAUSE, SCREAM, COPTER,SCRATCH, H2O & GLASS) may be added to your mix by pressingthe SOUND EFFECTS CONTROL BUTTONS. The volume of theeffects can be adjusted using the rotary EFX VOLUME locatedabove the APPLAUSE effect button. The pitch of the effects can beincreased or decreased using the rotary SPEED CONTROL locatedabove the SCRATCH effect button.32337