Gemini 953 Installation And Use Manual

Also see for 953: Installation and use manual Installation and use manual

Contents

Gemini 953 Installation And Use Manual Manual pdf 9 page image

2.0 - ALARM UNIT POSITIONING!!!!ing th in this position, will preventwater entering the unitIt is important to give the rubber sheath a ‘goose-neck’ bending as shown in the picture opposite andsecure with a tie wrap..Fitt e control unit.he!!!!Do not expose to atmospheric agents.Pay attention not to muffle the siren speakerSecure away from moving mechanical parts.Keep away from devices that could generate highfrequency electromagnetic disturbances.Keep away from devices that could reach hightemperatures when the vehicle is in use.Do not secure t control unit directly on the vehicleframe.Do not install the alarm unit in thisposition as water ingress over timemay seep through the rubber sheathand permanently damage theelectronic circuit making the alarmsystem unreliable.Eventual malfunctioning due to waterinfiltration is not covered by warranty.NO!OK!CAUTIONIf a jet wash is used to clean the vehicle, protect the alarm unit from watersplashes and be careful not to expose it to high pressure jets.The warranty will not cover damages to the system due to water infiltrationscaused by improper installation, jet washing or the use of non originalaccessories, not approved by the manufacturer.INSTALLER MANUAL1.0 - PRELIMINARY ADVICEPlease read all instructions and understand them thoroughly beforestarting installation.CONTENTS1.05.06.08.09.010.011.012.014.015.0- PRELIMINARY ADVICE- ELECTRICAL CONNECTIONS- WIRING DIAGRAM- ENGINE BLOCK WIRING CONNECTIONS (ground wire)- ENGINE BLOCK WIRING CONNECTIONS (cut- EXAMPLE OF-- DIODE INSTALLATION- LEARNING NEW DEVICES (with ground wire)LEARNING NEW DEVICES (without ground wire)- PROGRAMMABLE FEATURES- PROGRAMMING EXAMPLE2.03.04.07.013.016.0- ALARM UNIT POSITIONING- ALARM UNIT SEALING- ACCESSORIES POSITIONING4.1 - Receptacle for electronic key and LED indicator4.2 - Contact switch (optional)wire)ELECTRIC CONNECTIONS WITH SPECIFIC WIRING10.1 - Engine block connections10.2 - Turn indicator connections10.3 - Ground connection10.4 - Electronic key receptacle with built-in LED-- SHOCKENGINE BLOCK CONNECTIONS WITH SPECIFICWIRING HARNESSALHARNESSSENSOR ADJUSTMENTPage 15 Page 16