Gemini CDJ-15X Operation Manual

Also see for CDJ-15X: Operation manual

Contents

Gemini CDJ-15X Operation Manual Manual pdf 5 page image

( 5 )( 5 )( 5 )( 5 )( 5 )OPERATING INSTRUCTIONS:1. Make sure that the VOLTAGE SELECTOR SLIDE (3), found on the rearpanel, is set for the proper voltage. Plug the unit in and press thePOWER (2) switch.2. Press the OPEN (16) button, place a CD in the DISC TRAY (10) andclose the tray door. The display will initially show the number of tracksand the total time of the CD.3. Push the TRACK SKIP (6) buttons to select the track you want to play.4. Press the PLAY/PAUSE (9) button and the unit will instantly play.CUE INSTRUCTIONS:1. To start the play at a point other than the beginning of a track, followthese instructions:First choose the track you wish to play, and then press PLAY/PAUSE(9) so the unit goes into the play mode. Press PLAY/PAUSE (9) topause play at the spot where you want the play to start the CUEPOINT. Use the SEARCH BUTTONS (7) to pick the precise spot youwant play to begin, then press PLAY/PAUSE (9) again to save the cuepoint. Press the CUE (8) button to pause play at the cue point (the unitwill go into the pause mode and the location indicated on the display willbe the memorized cue point). You can preview the cue point bypressing and holding down CUE (8). Press PLAY/PAUSE (9) to beginplay from the cue point.NOTE: AFTER A CUE POINT IS SET, PRESSING THE TRACK SKIP (6) BUTTONS CLEARS THECUE POINT. WHEN YOU PRESS THE CUE (8) BUTTON IN THE NEW TRACK, THEBEGINNING OF THAT TRACK WILL BE THE NEW CUE POINT.2. Once you have saved a cue point you can fine tune or change thememorized cue point:To change a cue point, push PLAY/PAUSE (9) so the unit plays fromthe cue point, then press PLAY/PAUSE (9) at the spot you wish yournew cue point to be. Press PLAY/PAUSE (9) again to save the cuepoint. The unit will go into the pause mode and the location indicated onthe display will be the new memorized cue point.To fine tune a cue point, pause play at the memorized cue point, thenuse the SEARCH (7) buttons to scan frame by frame (1/75th of asecond) to where you want play to begin. Press PLAY/PAUSE (9) tosave the new cue point.NOTE: DURING FINE TUNING THERE WILL BE A STUTTER EFFECT (TO HELP YOU FIND THEBEAT). THE STUTTERING EFFECT WILL END WHEN YOU PRESS PLAY/PAUSE (9) TO SAVETHE CUE POINT. ALSO, DURING FINE TUNING IF YOU HOLD DOWN THE SEARCH (7)BUTTON, THE UNIT WILL SCAN QUICKLY AFTER 10 FRAMES.TROUBLE SHOOTING:• If the disk will not play, check to see if the disc was loaded correctly(label side up). Also check the disc for excessive dirt, scratches, etc.• If the disc turns but there is no sound, check the cable connections. Ifthey are okay, check your amplifier or receiver.• If the CD skips, check the CD for dirt or scratches. Do not assume thatthe CD player is defective. Many CDs are recorded out of spec and willskip on most or all CD players. Before sending the unit in for repair, tryplaying a CD that you are sure plays properly.SPECIFICATIONS:GENERAL:Disc Type........................................Standard Compact discs (12 cm & 8 cm)Time Display............................Track Elapsed, Track Remain, or Total remainVariable Pitch...........................................± 16% Slider with Resume SwitchStart................................................................................Within 0.03 secondsTrack Selection........................................................................1 to 99 TracksAUDIO SECTION:Quantization...........................................1 Bit Linear/Channel, 3 Beam LaserOversampling Rate.............................................................................8 TimesSampling Frequency.........................................................................44.1 kHzFrequency Response............................................................20 Hz to 20 kHzTotal Harmonic Distortion..................................................Less Than 0.005%Signal to Noise Ratio............................................................................>96 dBDynamic Range...................................................................................>94 dBOutput Level (nominal)..........................................................1.9 Volts R.M.S.Power Supply............................................................AC 120/230V, 60/50 HzDimensions..................................8.38” x 8.86” x 3.75” (213 x 225 x 95 mm)Weight.......................................................................................4.5 lbs. (2 kg)SPECIFICATIONS AND DESIGN ARE SUBJECT TO CHANGEWITHOUT NOTICE FOR PURPOSE OF IMPROVEMENT.