( 4 )1. Unscrew the outside FADER PLATE SCREWS (B).Do not touch the INSIDE SCREWS (C).2. Carefully lift the fader and unplug the CABLE (D).3. Plug the new fader into the cable and place it back inthe mixer.4. Screw the fader to the mixer.7. OUTPUT CONTROL SECTION: The level of the MASTEROUT (31) is controlled by the MASTER (23) slide. TheMaster TREBLE (20) and BASS (21) controls allow you toadjust the output of channels 1-4.NOTE: THE RECORD OUT (27) HAS NO LEVELCONTROL. THE LEVEL IS SET BY THE CHANNELSLIDES OF THE SELECTED CHANNEL.8. TALKOVER SECTION: The purpose of the talkover sectionis to allow the program playing to be muted so that the MICcan be heard above the music. The MIC 1/TALKOVERSWITCH (6) controls MIC 1 and has three settings. Whenthe MIC 1/TALKOVER SWITCH (6) is in the bottomposition, the MIC and talkover are off. When the MIC 1/TALKOVER SWITCH (6) is in the center position MIC 1 ison, the MIC 1 INDICATOR (7) will glow, but talkover is off.When the MIC 1/TALKOVER SWITCH (6) is in the topposition, MIC 1 and talkover will be on and the volume of allsources except the MIC input are lowered by 16dB. TheMIC LEVEL (16) controls the level of MIC 1.9. CUE SECTION: By connecting a set of headphones to theHEADPHONE (5) jack, you can monitor any or all of thechannels. Press the CUE ASSIGN (19) buttons forchannels 1-4 to select the channel or channels to bemonitored and their respective LED indicators will glow.Use the CUE LEVEL (24) control to adjust the cue volumewithout effecting the overall mix. By moving the CUEPGM PAN (22) control to the left you will be able to monitorthe assigned cue signal. Moving the control to the right willmonitor the PGM (program) output.10.DISPLAY: The DISPLAY (18) indicates the MASTERoutput left and right levels.SPECIFICATIONS:INPUTS:MIC 1..............................................1.5mV 2kOhm balancedMIC 2 ............................................1.5mV 2KOhm balancedPhono @ 1kHz...............................................2mV 47kOhmLine...........................................................100 mV 27kOhmOUTPUTS:Amp/Booth................................................0 dB 1V 400OhmMax....................20V Peak to PeakRec..............................................................225mV 5kOhmGENERAL:Bass....................................................................... ± 12dBTreble......................................................................± 12dBFrequency Response..........................20Hz - 20KHz +/- 2dBDistortion....................................................less than 0.02%S/N Ratio...................................................better than 80dBTalkover Attenuation....................................................-16dBPower Source:............................Adapter-115V/15V AC 0.5A..........................................................or 230V/15V AC 0.5ADimensions..................19”w x 3”d x 7”h (483 x 76 x 178 mm)Weight.......................................................6.25lbs (2.84 kg)