Genie 1028 Operation & Maintenance Manual

Also see for 1028: Programming, operation & maintenance manual

16Maintenance and Adjustments (continued)Changing Light Bulbs1. Disconnect power to door opener.Open powerhead light cover(s) by pressing down on upperlocking tabs.• Replace old light bulb(s) with new.• Use 60 watt incandescent bulbs or the CFL or LED equivalent.• Close powerhead light cover(s).2. Reconnect power to door opener.Test light operation.NOTE: Use of LED bulbs may reduce the range of yourremote controls.Visit www.GenieCompany.com for more information andrecommendations for LED bulbs.F. LIGHT BULB REPLACEMENTLIGHT BULBLIGHT COVERSWINGS OPENWARNING!• Use extreme caution when working from a ladder or stepstool or serious injury can occur.• When replacing light cover, make sure wires are not pinchedor near moving parts.• Use only properly rated incandescent, LED or CFL light bulbs.• DO NOT use bulbs with a rating greater than 60 Watts.• Use A19 size light bulbs. DO NOT use bulbs having a shortneck.AVERTISSEMENT!• Faire particulièrement attention lors de travaux effectuésdepuis une échelle ou en escabeau.• En referment le couvercle de l’éclairage, s’assurer que les filsne sont ni coincés ni près des pièces mobiles.• Utilisez uniquement incandescence correctement classé, LEDou des ampoules fluocompactes.• NE PAS utiliser des ampoules avec une note supérieure à 60Watts• Utilisez A19 ampoules de taille. NE PAS utiliser des ampoulesayant un cou court.