Genie M-4500 Owner's Manual

Genie M-4500 Owner's Manual Manual pdf 23 page image

Your opener can be activated via any of the following,depending on which accessories your opener system has: Remote Control Transmitter Wall Control Panel Doorbell-Type Pushbutton Keyless Entry (optional accessory p.28)REMOTE CONTROL TRANSMITTER: To open or close garage door, press and hold button(Midi transmitter has an indicator light that will startblinking). See Fig. 51A. When garage door begins tomove, release button. To stop garage door during travel, press and hold buttonuntil door stops, then release button. To resume garage door travel after stopping it, pressand hold button until door begins to move, thenrelease button.WALL CONTROL PANEL: The illuminated Door Pushbutton will light when properlyconnected (if it does not light up, review section 8-11.“Install Wall Control” on page 14 or refer to “Having aProblem” on page 29). To open or close garage door, press and hold IlluminatedDoor Pushbutton. See Fig. 51B. When garage door beginsto move, release button. To stop garage door during travel, press and hold buttonuntil door stops, then release button. To resume garage door travel after stopping it, pressand hold button until door begins to move, thenrelease button. The Light On /Off button can be used to turn lights onor off. Press light On /Off button until lights come on orturn off. Release button. When using the light On /Offbutton, the automatic timer is ignored, and the lights willremain on until the button is pressed again, or until theopener is activated and the automatic timer begins again. The Lock/Vacation button can be used to lock out allremote control transmitters. The door can still be acti-vated by wall control panel or keyless entry system.Press and hold Lock/Vacation button for 2-3 seconds.Release button. Illuminated Door Pushbutton will flashcontinuously while lock mode is active. To unlock opener,press and hold Lock/Vacation button for 2-3 seconds.DOORBELL-TYPE PUSHBUTTON: To open or close garage door, press and hold Pushbutton.See Fig. 51C. When garage door begins to move, releasebutton. To stop garage door during travel, press and hold buttonuntil door stops, then release button. To resume garage door travel after stopping it, pressand hold button until door begins to move, thenrelease button.OPENER LIGHTS: Lights will come on whenever opener is activated.Lights will stay on for 4 minutes and 15 seconds, or untilthe Light On /Off button on the wall control panel ispressed, whichever is sooner. Lights can be turned on and off manually as describedunder operation of wall control panel. Lights will flash when the opener senses an obstructioneither detected by the internal safety system or the photoeye. To stop lights from flashing, remove obstruction andoperate door normally.11. OPERATION OF YOUR OPENER23Lock/VacationButtonLight On/OffButtonIlluminatedDoor PushbuttonB. Wall Control Panel C. Doorbell-Type PushbuttonPushbuttonIndicator LightButtonsA. 2-Channel Midi TransmitterFig. 51Before you can use your car’s HomeLink® device to open agarage door you must transfer an active code from thetransmitter to the HomeLink® Universal Transceiver.(Reference - HomeLink® Manual)12. HOMELINK® TRANSCEIVER