Genie QuietLift 2040C Operation And Maintenance Manual

Also see for QuietLift 2040C: Operation and maintenance manual

Contents

Genie QuietLift 2040C Operation And Maintenance Manual Manual pdf 9 page image

For Help, call 1-800-35-GENIE or visit www.geniecompany.com 9NOTE• Each Remote Control must be programmed separately.• The Remote Controls will not cause the door Opener to closethe garage door if the Safe-T-Beam® System is malfunctioning.• When Programming the Remote Controls, they must be atleast 24” from the Antenna Wire.• If the red Learn Indicator Light blinks approximately 4 timesper second, programming has stopped, repeat the above steps.• Each Button on a 2 or 3 Button Remote Control is for adifferent Opener. You cannot use more than one Button perRemote, per Opener.• A maximum of seven Remote Controls or Wireless Keypadscan be stored into the Receiver at one time. If a RemoteControl becomes lost, or if you want to delete a RemoteControl or Wireless keypad, see “To Erase all Receiver Memory”Figure 3 Genie Remote Controls1 ButtonRemotew/Flashlight3 ButtonLargeRemotew/Flashlight3 ButtonRemotew/FlashlightFlashlight ButtonFrequencySwitchC Remote Control Operation.• Press Button on Remote Control. Garage door will move.• Press Button again. Garage door will stop:The door automatically stops at the end of the open orclose cycle.• Press Button again. Garage door will reverse.• Some Remote Controls are equipped with a flashlight. TheGenie logo is the button which operates the light. There is abacklight under the button. When it does not light, itindicates the battery needs replaced.AND GO OUTFigure 4 Erasing the remotesE Replacing the batteries.• Pop off the back of the transmitter using a coin.• Replace the battery with a new compatable cointype battery. (size 2032)• Snap the back of the transmitter on.CAUTIONShould a remote become lost or stolen it is imperative thatthe remote control codes be erased from the receivermemory and new codes programmed, to prevent themissing remote from being able to operate the door opener.NOTEIf the light on the remote glows dimly or does not lightwhen operating the remote, replace the batteries.D Erasing all remotes (Figure 4).• Press and hold Learn Button on Power Head until LearnIndicator Light goes out. Memory is erased.• Program receiver again as needed.Transmitter Compliance Statement