3 - 10 S-60 • S-65 Part No. 77828July 2005Section 3 • Scheduled Maintenance ProceduresREV CA-7Test the Oscillate Axle(if equipped)Proper axle oscillation is essential to safe machineoperation. If the axle oscillation system is notoperating correctly, the stability of the machine iscompromised and it may tip over.1 Start the engine from the platform controls.2 Drive the right steer tire up onto a6 inch / 15 cm block or curb.Result: The three remaining tires should stay infirm contact with the ground and the chassisshould remain level at all times.3 Drive the left steer tire up onto a6 inch / 15 cm block or curb.Result: The three remaining tires should stay infirm contact with the ground and the chassisshould remain level at all times.4 Drive both steer tires up onto a6 inch / 15 cm block or curb.Result: The non-steer tires should stay in firmcontact with the ground.If the chassis does not remainlevel during test, see RepairProcedure 7-6,How to Set Up theOscillate Directional Valve.A-8Perform 30 Day ServiceThe 30 day maintenance procedure is a one timesequence of procedures to be performed after thefirst 30 days or 50 hours of usage, whichevercomes first. After this interval, refer to themaintenance tables for continued scheduledmaintenance.1 Perform the following maintenance procedures:• A-9 Perform Engine Maintenance -GM, Ford and Perkins Models• A-12 Grease the Turntable Bearing andRotate Gear• B-5 Check the Lug Nut Torque(including tires and wheels)• B-7 Check the Oil Level in the Drive Hubs• C-1 Perform Engine Maintenance -Deutz Models• D-2 Check the Turnable Rotation BearingBolts• D-6 Replace the Hydraulic FiltersCHECKLIST A PROCEDURES
