©2010 The Genie Company 12/2010 15OVERVIEW - REMOTES AND OPTIONS5FCC and IC CERTIFIEDThis device complies with FCC Part 15 and RSS210 of Industry Canada. This equipment has beentested and found to comply with the limits for aClass B digital device, pursuant to Part 15 of theFCC Rules. These limits are designed to providereasonable protection against harmful interferencein a residential installation. This equipmentgenerates, uses and can radiate radio frequencyenergy and, if not installed and used in accordancewith the instructions, may cause harmfulinterference to radio communications. However,there is no guarantee that interference will notoccur in a particular installation. If this equipmentdoes cause harmful interference to radio ortelevision reception, which may be determinedby turning the equipment OFF and ON, the user isencouraged to try to correct the interference byone or more of the following measures:• Re-orient or relocate the receiver antenna.• Increase the separation between the opener andreceiver.• Connect the opener into an outlet on a circuitdifferent from that to which the receiver isconnected.• Consult your local dealer.FIG. 5-1 RemoteWARNINGA moving door can cause serious injury or death.1. Keep people clear of opening while door ismoving.2. Do NOT allow children to play with opener,including wall console, remote, or wirelesskeypad.3. During programming, the door opener couldbegin to run, so keep people and objects awayfrom the moving door and its parts. To keep thedoor from moving, close the door and disconnectit from the rail carriage by pulling the EmergencyRelease Handle. See page 19 for Release Handleoperation.Three ButtonRemoteSee page 21 for battery changing instructions.LOST OR STOLEN REMOTE - CLEARING MEMORYClearing remotes from powerhead memory willclear ALL programmed remotes and wirelesskeypad.NOTE: Follow the PROGRAM REMOTE TOPOWERHEAD steps to re-enter remaining or newremotes. See page 9.1. Press PROGRAMSETand holduntil both lightscome ON BLUE.Release button.2. Lights go out and RoundBLUE light comes ON.3. Press PROGRAMSET again andlong LED flashesPURPLE.PROGRAMSET—+PROGRAMSET—+4. Press both andsimultaneously on thepowerhead and hold untilboth LEDs flash BLUE.• Verify memory is cleared. Press a remotebutton that was previously programmed tothe powerhead. Remote will not activate dooropener.• Garage door opener will operate normally usingwall console.• Program remaining or new remotes as shownon page 9. Your door opener will no longerrecognize any signal received from the missingremote, or any other which has not beenreprogrammed to the powerhead.PROGRAMSET—+