Please read these instructions carefully before operating this unit,and retain this manual for future referencePrecautions• Do not install the camera in extreme temperature conditions. Only usethe camera under conditions where temperatures are within -10℃ ~+50℃. Be especially careful about ventilation in high temperatures.• Do not drop the camera or subject it to physical shocks. This can causemalfunctions to occur.• Do not install the camera under unstable lighting conditions. Severelighting change or flicker can cause the camera to work improperly.• Do not disassemble the camera. There are no user serviceable partsinside it.• Do not expose the camera to rain or moisture. If it gets wet, wipe it dryimmediately. Liquids can contain minerals that corrode electrical parts.Features• 1/3” Colour CCD• Internal Micro Dome Camera• Ø57mm Dome Cover• 620TVL - High Resolution• Min Illumination 0.03Lux• Digital Noise Reduction (DNR)• DC12V Only• Black or White Housing OptionsPower and Video ConnectionTroubleshootingDimensionsCamera Manual InstallationScrewsGift BoxProblem What To Do?No video on the monitorscreen• Check camera and monitor power.• Check the power polarity.• Check the video cable connection.Colour rolling • This can occur if the camera is exposed to astrong light source• If there is a strong light present, change theposition of the camera.The On-Screen imageis dim• Check if the lens/bubble is dirty. If it is, clean witha soft line free cloth.• Check the monitor contrast and brightness.Black bars roll up or downthe screen, or there isvideo noise• Make sure the power adapter is at least 500mA• Make sure there are no ground loops• Noise could be caused by a poor connection12VDC : REDBNC :YELLOW650mmCABLE DIAMETER : ¢4.5PIN PITCH:1.25㎜HOUSING:51021-03MOLEX35mm12VDC : REDBNC :YELLOW650mmCABLE DIAMETER : ¢4.5PIN PITCH:1.25㎜HOUSING:51021-03MOLEX35mm