Genie WNVR432P5OAI Quick Start Manual

14NAT Settings1. The NVR shall be powered on and connected to the network.2. Go to Start → Settings → Network → TCP/IP. You can obtain the IP address, subnet maskand gateway automatically. You can also manually enter them according to the actualnetwork situation. Please make sure the network segment is the same as that of thenetwork which is used.3. Set the preferred or alternative DNS Server. Click “Apply” to save the parameters.4. Go to Start → Settings → Network → NAT tab. Enable NAT and select the NAT ServerAddress (The default NAT Server Address is nat.autonat.com). Click “Apply” to save theparameters.NAT AccessAfter finishing the NAT settings, you can enter www.autonat.com in the address bar ofyour browser and then press enter to go to the following interface. If you are the first timeto access the NAT, you shall download and install the plug-in according to the tips. Afterinstalling the plug-in successfully, it will pop up the login box.Device Serial Number:Click on the menu bar at the bottom of the live interface to check the serial number orgo to Start → Settings → Network → Network Status to check the serial number of the NVR).Username:The username of the NVR. The default username is admin.Password:The password of the NVR. The password is set by yourself when you configure the wizardfor the first time.8.0 NAT

/ 16

Related manuals for Genie WNVR432P5OAI