87On the Use of the RF Devi ceUSA and Canada Safety Requi rements and Noti cesMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the antennaused for this transmitter must be installed to provide a separation distance of at least20 cm from all persons and must not be co-located or operating in conjunction withany other antenna or transmitter.Radi o Frequency Interference Requi rements and SARThis device meets the government’s requirements for exposure to radio waves.This device is designed and manufactured not to exceed the emission limits for exposureto radio frequency (RF) energy set by the Federal Communications Commission ofthe U.S. Government.This device complies with FCC radiation exposure limits set forth for an uncontrolledenvironment.EMC Requi rementsThis device uses, generates and radiates radio frequency energy. The radio frequencyenergy produced by this device is well below the maximum exposure allowed bythe Federal Communications Commission (FCC).This device complies with the limits for a Class B digital device pursuant to Part15 subpart C of the FCC Rules and Regulations. Operation is subject to the followingtwo conditions:(1) This device may not cause harmful interference.(2) This device must accept any interference received, including interference thatmay cause undesired operation.The FCC limits are designed to provide reasonable protection against harmfulinterference when the equipment is installed and used in accordance with theinstruction manual and operated in a commercial environment. However, there isno guarantee that interference will not occur in a particular commercial installation,or if operated in a residential area.
