H3C LS-3100-16TP-EI-H3-A-O Installation Manual

Contents

H3C LS-3100-16TP-EI-H3-A-O Installation Manual Manual pdf 89 page image

Installation ManualH3C S3100 Series Ethernet Switches Chapter 5 Boot ROM and Host Software Loading5-92. Set FTP protocol parameter3. Set XMODEM protocol parameter0. Return to boot menuEnter your choice(0-3):Step 4: Enter 1 to download the Boot ROM software using TFTP. Then set the followingTFTP-related parameters as required:Load File name :S3100-SI.btmSwitch IP address :1.1.1.2Server IP address :1.1.1.1Step 5: Press <Enter>. The system displays the following information:Are you sure to update your bootrom?Yes or No(Y/N)Step 6: Enter Y to start file downloading or N to return to the BootROM update menu. Ifyou enter Y, the system begins to download and update the Boot ROM software. Uponcompletion, the system displays the following information:Loading........................................doneBootrom updating..........done!III. Loading host softwareFollow these steps to load the host software of the switch.Step 1: Select <1> in Boot Menu. The system displays the following information:1. Set TFTP protocol parameter2. Set FTP protocol parameter3. Set XMODEM protocol parameter0. Return to boot menuEnter your choice(0-3):1The subsequent steps are the same as those for loading the Boot ROM software,except that the system gives the prompt for host software loading instead of Boot ROMloading.5.2.4 Loading Software Using FTP Through Ethernet PortI. Introduction to FTPFTP is an application-layer protocol in the TCP/IP protocol suite. It is used fortransferring files between server and client. FTP runs over UDP to provide unreliabledata transmission.You can use FTP to load software to the switch through an Ethernet port. In this case,the switch can act as an FTP server or an FTP client. In the following example, theswitch acts as an FTP client.