Installation ManualH3C S5500-SI Complete Series Ethernet Switches Chapter 5 Boot ROM and Host Software Loading5-11Step 5: Press after inputting the information above. The system displays thefollowing information:Are you sure to update your bootrom?Yes or No(Y/N)Step 6: Enter Y to start file downloading or N to return to the Boot ROM update menu. Ifyou enter Y, the system begins to download and update the program. Upon completion,the system displays the following information:Loading........................................doneBootrom updating..........done!III. Loading host softwareStep 1: Select 1 in Boot Menu to load the host software of the switch. The systemdisplays the following information:1. Set TFTP protocol parameter2. Set FTP protocol parameter3. Set XMODEM protocol parameter0. Return to boot menuEnter your choice(0-3):2To load the host software through FTP, select 2.The subsequent steps are the same as those for loading the Boot ROM software,except that the system gives the prompt for host software loading instead of Boot ROMloading.5.3 Remote Software LoadingYou can telnet to the switch, and use FTP or TFTP to load Boot ROM and host softwareremotely.5.3.1 Remote Loading Using FTPAs shown in Figure 5-8, a PC is used as both configuration device and FTP server. Youcan telnet to the switch, and then execute the FTP commands to download the hostprogram s5500-SI.bin and the Boot ROM program S5500-SI.btm from the remote FTPserver (with IP address 10.1.1.1) to the switch.PCFTP ClientSwitchEthernet portIP networkFTP Server10.1.1.1Figure 5-8 Load software using FTP remotelyStep 1: Download the software to the switch using FTP commands.
