Operation Manual – CLIH3C S3100-52P Ethernet Switch Chapter 1 CLI Configuration1-8 system-view[Sysname] user-interface vty 0[Sysname-ui-vty0] super authentication-mode scheme[Sysname-ui-vty0] quit# Specify to adopt the HWTACACS authentication scheme named acs for user levelswitching in the ISP domain named system.[Sysname] domain system[Sysname-isp-system] authentication super hwtacacs-scheme acs# Switch to user level 3 (assuming that you log into the switch as a VTY 0 user byTelnet). super 3Username: user@systemPassword:User privilege level is 3, and only those commands can be usedwhose level is equal or less than this.Privilege note: 0-VISIT, 1-MONITOR, 2-SYSTEM, 3-MANAGE1.3 CLI ViewsCLI views are designed for different configuration tasks. They are both correlated anddistinguishing. For example, once a user logs into a switch successfully, the user entersuser view, where the user can perform some simple operations such as checking theoperation status and statistics information of the switch. After executing thesystem-view command, the user enters system view, where the user can go to otherviews by entering corresponding commands.Table 1-1 lists the CLI views provided by S3100-52P Ethernet switches, operations thatcan be performed in different CLI views and the commands used to enter specific CLIviews.Table 1-1 CLI viewsView AvailableoperationPromptexample Enter method Quit methodUser viewDisplayoperationstatus andstatisticalinformation ofthe switchEnter userview oncelogging intothe switch.Execute thequit commandto log out ofthe switch.System viewConfiguresystemparameters[Sysname]Execute thesystem-viewcommand inuser view.Execute thequit or returncommand toreturn to userview.