Operation Manual – Port MirroringH3C S3610&S5510 Series Ethernet Switches Chapter 1 Port Mirroring Configuration1-7To do… Use the command… RemarksIn systemviewmirroring-group group-idmonitor-port monitor-port-idinterface interface-typeinterface-number[ mirroring-group group-id ]monitor-portAdd a portto the portmirroringgroup asthedestinationportIn interfaceviewquitYou can add aport to aremote portmirroring groupas thedestinationport in eithersystem view orinterface view.They achievethe samepurpose.Enter destination interfaceviewinterface interface-typeinterface-number —The port isan accessportport access vlan rprobe-vlan-idThe port is atrunk portport trunk permit vlanrprobe-vlan-idAdd theport to theremoteportmirroringVLAN The port is ahybrid portport hybrid vlan rprobe-vlan-id{ tagged | untagged }Perform one ofthese threeoperationsaccording tothe port type.Note:z A destination port cannot be a member port of the current mirroring group.z A port can be configured in only one mirroring group, and a VLAN can be used byonly one mirroring group.z It is not recommended to enable STP, RSTP or MSTP on the destination port;otherwise, the mirroring function may be affected.z Only existing static VLANs can be configured as remote port mirroring VLANs. Toremove a VLAN operating as a remote port mirroring VLAN, you need to restore it toa normal VLAN first. A remote port mirroring group gets invalid if the correspondingremote port mirroring VLAN is removed.1.4 Displaying Port MirroringFollow these steps to display port mirroring:To do… Use the command… RemarksDisplay the configurationof a port mirroring groupdisplay mirroring-group { groupid |all | local | remote-destination |remote-source }Available inany view