H3C S3610 Series Operation Manual

Also see for S3610 Series: Configuration Quick start Operation manual Operation manual Operation manual

Contents

H3C S3610 Series Operation Manual Manual pdf 9 page image

Operation Manual – Link AggregationH3C S3610&S5510 Series Ethernet Switches Chapter 2 Link Aggregation Configuration2-1Chapter 2 Link Aggregation ConfigurationWhen configuring link aggregation, go to these sections for information you areinterested in:z Configuring Link Aggregationz Displaying and Maintaining Link Aggregationz Link Aggregation Configuration Example2.1 Configuring Link AggregationThis section covers these topics:z Configuring a Manual Link Aggregation Groupz Configuring a Static LACP Link Aggregation Groupz Configuring an Aggregation Group Namez Configuring a Service Loop Groupz Entering Aggregation Port Group View2.1.1 Configuring a Manual Link Aggregation GroupFollow these steps to create a manual aggregation group and add an Ethernet port to it:To do… Use the command… RemarksEnter system view system-view ––Create a manualaggregation grouplink-aggregation group agg-idmode manual RequiredEnter Ethernet port view interface interface-typeinterface-number ––Assign the Ethernet portto the aggregation groupport link-aggregation groupagg-id RequiredNote that:z You can create a manual aggregation group by changing the type of an existingstatic aggregation group. When you create a manual aggregation group in thisway and the static aggregation group contains ports, LACP is disabled on the portsafter the manual aggregation group is created.z An aggregation group cannot contain the following ports: RRPP-enabled ports,reflector ports or destination ports of port mirroring groups, ports with static MAC

/ 14

Related manuals for H3C S3610 Series

H3C S3610 Series Operation Manual

This manual is suitable for:

S3610 Series S5510 Series

manualsdatabase

Your AI-powered manual search engine