Operation Manual – Cluster ManagementH3C S3610&S5510 Series Ethernet Switches Chapter 1 Cluster Management Configuration1-12To do... Use the command... RemarksEnter system view system-view —Specify the managementVLANmanagement-vlanvlan-idOptionalBy default, VLAN 1 is themanagement VLAN.Enter cluster view cluster —Configure the private IPaddress range formember devices on adevice which is to beconfigured as themanagement deviceip-pooladministrator-ip-address{ mask | mask-length }RequiredFor a cluster to worknormally, the IP addressesof the VLAN interfaces ofthe management deviceand member devices mustnot be in the same networksegment as the clusteraddress pool.Set up a clusterautomatically auto-build [ recover ] RequiredCaution:To make a cluster to operate properly, the IP addresses of the VLAN interfaces of themanagement device and the member devices and those in the cluster address poolcannot be in the same segment.1.3.7 Configuring Member ManagementMember management includes the following aspects:z Manually adding a candidate device to a cluster, or deleting a member device froma cluster. These operations must be done through the management device,otherwise you will be prompted with an error message.z Communication between the management and member devices may beinterrupted due to some configuration errors. Through the remote control functionof member devices, you can control them remotely on the management device.For example, you can reboot a member device that operates improperly andspecify to delete the booting configuration file when the member device reboots,and thus achieve normal communication between the management and memberdevices.z Switching between the management device view and the member device view forconfiguration and managementFollow these steps to configure member management: