40To do... Use the command... RemarksAssign the port anaggregation prioritylink-aggregationport-priority port-priorityOptionalBy default, the aggregation priority of a port is 32768.Changing the aggregation priority of a port might affectthe aggregation state of the ports in the dynamicaggregation group.Set the LACP timeoutinterval on the port tothe short timeout interval(1 second)lacp period shortOptionalBy default, the LACP timeout interval on a port is thelong timeout interval (30 seconds).Configuring an aggregate interfaceNOTE:Most of the configurations that can be performed on Ethernet interfaces can also be performed onaggregate interfaces.Configuring the description of an aggregate interfaceYou can configure the description of an aggregate interface for administration purposes such asdescribing the purpose of the interface.Follow these steps to configure the description of an aggregate interface:To do... Use the command... RemarksEnter system view system-view —Enter aggregate interface view interface bridge-aggregationinterface-numberRequiredUse either command.Configure the description of theaggregate interface description textOptionalBy default, the description of aninterface is in the format ofinterface-name Interface, such asBridge-Aggregation1 Interface.Enabling link state traps for an aggregate interfaceYou can configure an aggregate interface to generate linkUp trap messages when its link goes up andlinkDown trap messages when its link goes down. For more information, see Network Management andMonitoring Configuration Guide.Follow these steps to enable link state traps on an aggregate interface:To do... Use the command... RemarksEnter system view system-view —
