H3C S5120-SI Series Installation Manual

Also see for S5120-SI Series: Quick start guide Operation manual Configuration guide Command reference Configuration guide

Contents

H3C S5120-SI Series Installation Manual Manual pdf 50 page image

5-143. Set XMODEM protocol parameter0. Return to boot menuEnter your choice(0-3):3You can enter 1 to load the application file.The procedure of loading an application file is similar to that of loading a Boot ROM file. The differencelies in that the system displays the prompt of loading the application file rather than the Boot ROM file.After loading the application file, the switch displays that you should configure the application attribute,that is, main, backup, or none. Type a specific attribute to complete loading the application file.Writing flash..................................................................................Done!Please input the file attribute (Main/Backup/None) MDone!If an application file with a specific attribute already exists when you set a new file with the attribute, theattribute of the existing file becomes none after the new file becomes effective.Loading Files Using FTP Through Ethernet PortIntroduction to FTPThe switch can serve as either an FTP server or an FTP client by using its Ethernet port to download thesystem application and configuration files. The switch serves as an FTP client in the followingexamples.Loading a Boot ROM fileWhen loading a Boot ROM file, the switch can serve only as an FTP client.Complete the following tasks to load a Boot ROM file using FTP through an Ethernet port (For detailsabout the HyperTerminal, refer to “Setting Terminal Parameters” on page 4-2):Task RemarksSet up the configuration environmentRequiredConnect the switch to the TFTP server throughan Ethernet port, and to a PC through theconsole port. The PC and the TFTP server canbe the same device.Run the FTP Server program on the server Required