H3C S5500-EI Series Command Manual

Also see for S5500-EI series: Operation manual Operation manual Configuration guide Operation manual – port security Configuration guide

Contents

H3C S5500-EI Series Command Manual Manual pdf 8 page image

Command Manual – NTPH3C S5500-EI Series Ethernet Switches Chapter 1 NTP Configuration Commands1-7ParametersNoneDescriptionUse the ntp-service authentication enable command to enable NTP authentication.Use the undo ntp-service authentication enable command to disable NTPauthentication.By default, NTP authentication is disabled.Examples# Enable NTP authentication. system-view[Sysname] ntp-service authentication enable1.1.6 ntp-service authentication-keyidSyntaxntp-service authentication-keyid keyid authentication-mode md5 valueundo ntp-service authentication-keyid keyidViewSystem viewParameterskeyid: Authentication key ID, in the range of 1 to 4294967295.authentication-mode md5 value: Specifies to use the MD5 algorithm for keyauthentication, where value represents authentication key and is a string of 1 to 32characters.DescriptionUse the ntp-service authentication-keyid command to set the NTP authenticationkey.Use the undo ntp-service authentication-keyid command to remove the set NTPauthentication key.By default, no NTP authentication key is set.