Operation Manual – Information CenterH3C S5500-SI Series Ethernet Switches Chapter 1 Information Center Configuration1-6II. Enabling the display of system information on the consoleAfter configuring to output system information to the console, you need to enable theassociated display function in order to display the output information on the console.Perform the following configurations in user view to enable the display of systeminformation on the console:To do… Use the command… RemarksEnable the monitoring ofsystem information on theconsoleterminal monitorRequiredThe monitoring of systeminformation on theconsole is enableddefault.Enable the display ofdebug information on theconsoleterminal debugging RequiredDisabled by defaultEnable the display of loginformation on theconsoleterminal logging OptionalEnabled by defaultEnable the display of trapinformation on theconsoleterminal trapping OptionalEnabled by default1.2.2 Configuring to Output System Information to a Monitor TerminalSystem information can also be output to a monitor terminal, which is a user terminalthat has login connections through the AUX, VTY, or TTY user interface.I. Configuring to output system information to a monitor terminalFollow these steps to configure to output system information to a monitor terminal:To do… Use the command… RemarksEnter system view system-view —Enable information center info-center enable OptionalEnabled by defaultName the channel with aspecified channel numberinfo-center channelchannel-number namechannel-nameOptionalRefer to Table 1-3 fordefault channel namesConfigure the channelthrough which systeminformation can be outputto a monitor terminalinfo-center monitorchannel{ channel-number |channel-name }OptionalSystem information isoutput to the monitorterminal by default withchannel 1 as the defaultchannel