Operation Manual – QoSH3C S5500-SI Series Ethernet Switches Chapter 3 QoS Policy Configuration3-9Configure a policy named “test”. Specify the traffic behavior test_behavior for thepackets belonging to the test_class in the policy and apply the policy on the inbounddirection of GigabitEtherenet1/0/1.2) Configuration procedure# Enter system view. system-view# Define the policy and enter policy view.[H3C]qos policy test# Specify the traffic behavior for the class.[H3C-qospolicy-test] classifier test_class behavior test_behavior[H3C-qospolicy-test] quit# Enter Ethernet port view.[H3C] interface GigabitEthernet 1/0/1# Apply the policy on the interface.[H3C-GigabitEthernet1/0/1] qos apply policy test inbound3.5 Displaying QoS PolicyAfter finishing the configurations mentioned above, you can execute the displaycommand in any view to check the running status of QoS Policy to verify theconfiguration.Table 3-7 Display QoS PolicyTo do… Use the command… RemarksDisplay the configurationinformation of the specified class orall classes in the specified policy orall policies and the configurationinformation of the behavior(s)associated with the class(es)display qos policyuser-defined[ policy-name [ classifiertcl-name ] ]Display the configurationinformation and running status ofthe policy on the specified port orall portsdisplay qos policyinterface [ interface-typeinterface-number ][ inbound ]Display the configured trafficbehavior informationdisplay traffic behavioruser-defined[ behavior-name ]Display the configured classinformationdisplay traffic classifieruser-defined [ tcl-name ]You canexecute thedisplaycommand inany view.