50Configuration example1. Network requirements• Enable byte-count WRR on port GigabitEthernet 1/0/1.• Assign queues 0 through 7 to the WRR group, with their weights being 1, 2, 4, 6, 8, 10, 12, and14.2. Configuration procedure# Enter system view. system-view# Configure WRR queuing on GigabitEthernet 1/0/1.[Sysname] interface GigabitEthernet 1/0/1[Sysname-GigabitEthernet1/0/1] qos wrr[Sysname-GigabitEthernet1/0/1] qos wrr 0 group 1 byte-count 1[Sysname-GigabitEthernet1/0/1] qos wrr 1 group 1 byte-count 2[Sysname-GigabitEthernet1/0/1] qos wrr 2 group 1 byte-count 4[Sysname-GigabitEthernet1/0/1] qos wrr 3 group 1 byte-count 6[Sysname-GigabitEthernet1/0/1] qos wrr 4 group 1 byte-count 8[Sysname-GigabitEthernet1/0/1] qos wrr 5 group 1 byte-count 10[Sysname-GigabitEthernet1/0/1] qos wrr 6 group 1 byte-count 12[Sysname-GigabitEthernet1/0/1] qos wrr 7 group 1 byte-count 14Configuring WFQ queuingConfiguration procedureFollow these steps to configure a WFQ queue:To do… Use the command… RemarksEnter system view system-view —Enterinterfaceviewinterface interface-type interface-numberEnterinterfaceview or portgroup view Enter portgroup view port-group manual port-group-nameUse either commandSettings in interface view takeeffect on the current interface;settings in port group view takeeffect on all ports in the port group.Enable WFQ queuing qos wfqRequiredThe default queuing algorithm onan interface is WRR queuing.Configure the minimumguaranteed bandwidth for aWFQ queueqos bandwidth queue queue-id minbandwidth-valueOptional64 kbps by defaultSpecify the queue schedulingweight for a WFQ queue qos wfq queue-id weight schedule-value Optional1 by defaultDisplay WFQ queuingconfigurationdisplay qos wfq interface [ interface-typeinterface-number ] [ | { begin | exclude |include } regular-expression ]OptionalAvailable in any view
