176Displaying and maintaining SSHExecute display commands in any view.Task CommandDisplay the source IP address or sourceinterface information configured for the SFTPclient.display sftp client sourceDisplay the source IP address or sourceinterface information configured for the Stelnetclient.display ssh client sourceDisplay SSH server status information or sessioninformation on an SSH server. display ssh server { session | status }Display SSH user information on the SSHserver. display ssh user-information [ username ]Display the public keys of the local key pairs. display public-key local { dsa | rsa } public [ namepublickey-name ]Display the public keys of the SSH peers. display public-key peer [ brief | name publickey-name ]Stelnet configuration examplesThis section provides examples of configuring Stelnet.Unless otherwise noted, devices in the configuration examples are in non-FIPS mode.Password authentication enabled Stelnet server configurationexampleNetwork requirementsAs shown in Figure 46, you can log in to the switch through the Stelnet client that runs on the host and areassigned the user role network-admin for configuration management. The switch acts as the Stelnet serverand uses password authentication. The username and password of the client are saved on the switch.Figure 46 Network diagramConfiguration procedure1. Configure the Stelnet server:# Generate the RSA key pairs. system-view[Switch] public-key local create rsaVlan-int2192.168.1.40/24Stelnet client Stelnet serverHost192.168.1.56/24Switch
