H3C S6300 Series Evb Configuration Manual

Also see for S6300 Series: Installation guide Troubleshooting guide Configuration Examples Installation, quick start Configuration guide

Contents

H3C S6300 Series Evb Configuration Manual Manual pdf 16 page image

9VSI interfaces or VSI aggregate interfaces are typically created by a VSI manager. You can create a VSIinterface or VSI aggregate interface, or modify its Pre-Associate and Associate properties through thistask.To create a VSI interface or VSI aggregate interface:Step Command Remarks1. Enter system view. system-view N/A2. Enter S-channel interfaceview or S-channel aggregateinterface view.interface { s-channel |schannel-aggregation }interface-number:channel-idN/A3. Create a VSI interface or VSIaggregate interface.evb vsi vsi-local-id { association |pre-association }By default, no VSI interface or VSIaggregate interface exists on anS-channel.Configuring VSI filtersThe EVB bridge uses a VSI filter to identify VSI traffic for a VM. Filters are usually assigned by a VSImanager. You can manually create or remove VSI filters through this task.A VSI filter contains a set of VID values, MAC addresses, and group ID values. EVB supports thefollowing filter info formats:• VLAN ID• VLAN ID + MAC• Group ID + VLAN ID• Group ID + VLAN ID + MACWhen you configure VSI filters on a VSI interface, follow these guidelines:• Before you configure a VSI filter on a VSI interface, make sure the S-channel interface to which theVSI interface belongs operates in trunk mode. Otherwise, the VSI filter configuration fails.• After you configure a VSI filter on a VSI interface, an S-channel interface automatically permits theVLAN that is configured in the VSI filter for the subordinate VSI interface. The same rule takes effecton Layer 2 interfaces associated with S-channels.• When you delete a VSI filter that contains information about a VLAN on a VSI interface, the otherVSI filters on all VSI interfaces of an S-channel interface might not contain the VLAN. If they do not,the S-channel interface automatically denies traffic from the VLAN that is configured on the VSI filter.The same rule takes effect on Layer 2 interfaces associated with S-channels.• When a filter configured on a VSI contains information about a VLAN, you must not configure thefilter on the same VSI interface again or on other VSI interfaces of the S-channel interface. If you do,an error message appears.• If the VSI filter is a set of VID values, and the MAC address learning function for the correspondingS-channel is disabled, traffic for the VSI cannot be forwarded.• Activate a VSI interface after configuring a VSI filter, and deactivate a VSI interface before removinga VSI filter.When you configure VSI filters on a VSI aggregate interface, follow these guidelines: