Command Manual – System Maintenance and DebuggingH3C S9500 Series Routing SwitchesChapter 1 System Maintenance andDebugging Commands1-11 display versionH3C Comware Platform SoftwareComware software, Version 3.10, Feature 1631Copyright(c) 2004-2007 Hangzhou H3C Technologies Co., Ltd. All rightsreserved.H3C S9505 uptime is 0 week, 2 days, 4 hours, 19 minutesLSB1SRP1N6 1: uptime is 0 week,2 days,4 hours,19 minutesH3C S9500 with 1 MPC755 Processor512M bytes SDRAM16384K bytes Flash Memory512K bytes NVRAM MemoryPCB Version : Ver.BBootROM Version : 123CPLD Version : 001Software Version : S9500-CMW310-F1631LSB1GT12B0 3: uptime is 0 week,2 days,4 hours,17 minutesH3C S9500 LPU with 1 MPC8245 Processor128M bytes SDRAM0K bytes NVRAM MemoryPCB Version : REV.0BootROM Version : 1031.3 System Debugging Commands1.3.1 debuggingSyntaxdebugging { all | timeout interval | module-name [ debugging-option ] }undo debugging { all | module-name [ debugging-option ] }ViewUser viewParametersall: Enables or disables all the debugging.timeout interval: Specifies the interval (in minutes) during which the debugging allswitch is on. The value ranges from 1 to 1440. With this configuration, all debuggingtakes the time at which it is enabled as the start time, and takes effect during thepredefined time. And after that, all debugging is disabled.