Installation ManualH3C SecPath F100-A Firewall Chapter 4 Firewall Configuration4-5III. Checking after power-upAfter the firewall is powered up, please check:z The LEDs on the front panel are normal.Refer to section 1.2.3 “LEDs” for the LED description.z The console terminal display is correct.After powering up the firewall, you can see the startup window on the console terminal(see section 4.1.3 “Booting Process”). After the startup (or power-on self-test), you areprompted to press . When the prompt appears, the system is ready foryour configuration.4.1.3 Booting ProcessAfter being powered up, the firewall first runs the Boot ROM program. The terminalscreen displays the following system information.Note:The contents displayed on the terminal may vary with Boot ROM versions.*************************************************** ** H3C SecPath Series Gateway Boot ROM V1.17 ** ***************************************************Copyright(C) 2004-2007 by Hangzhou H3C Technologies Co.,Ltd.Compiled at Wed Apr 12 17:39:36 CST 2006Testing memory...OK!256M bytes DDR SDRAM Memory16M bytes Flash MemoryHardware Version is 3.0CPLD Version is 1.0Press Ctrl-B to enter Boot MenuPress right now and the system will enter the Boot menu. Otherwise, thesystem will start the program decompression process.
