Safety recommendations 安全注意事项Installation site requirements 安装环境要求Item项目Specifications要求Tool list 工具参考To avoid device damage or bodily injury, read the following safety recommendations before installation.Note that the recommendations do not cover every possible hazardous condition.为了避免在安装路由器过程中对人和设备造成伤害,请您在安装前仔细阅读本节的安全建议。实际情况中包括但不限于以下安全注意事项:Flat-headscrewdriver一字螺丝刀• Before using the router, carefully read the warnings and safety symbols on the router andoperate the router accordingly.• When installing the router and modules, wear an ESD wrist strap and make sure the wrist strapmakes good skin contact and is reliably grounded.• Do not power on the router before you complete router installation and cabling.• To avoid device damage or bodily injury, make sure the router is reliably grounded beforepowering on the router.• For good ventilation of the router, install filler panels in the empty slots.• 使用设备前,请仔细识别设备上的警告和安全标识,并遵循标识的提示进行操作。• 安装设备及各类可插拔模块时,请佩戴防静电腕带并确保防静电腕带已经良好接地。• 设备安装和布线完成前禁止向设备供电。• 请您确保设备接地后再接通电源,以免危及人身和设备安全。• 为保证设备正常的通风散热,设备的空槽位请及时安装上假面板。The installation tools are not provided with the router. Prepare them yourself.路由器不随机提供安装工具,请用户根据实际安装需求自己准备安装工具。• Take dust-proof and anti-corrosion measures for the installation site.• Make sure the air inlet and outlet vents are not blocked and the installation site has a goodventilation system.• Reserve enough clearance around the rack. As a best practice, reserve a minimum of 0.8 m(2.62 ft) of clearance between the rack and walls or other devices.• The temperature and humidity of the installation site must be within the operating temperatureand humidity range, respectively.• 安装场所应做好防尘和防腐蚀措施。• 请确保路由器的进、出风孔不被遮挡,并将路由器安装在具有良好通风散热系统的环境中。• 机柜前后应预留足够的空间,建议机柜前后与墙面或其它设备的距离不应小于0.8m。• 安装场所的温湿度应保持在设备可正常工作的温湿度范围内。H3C SR6608-M Router Installation Quick Start-APW102H3C SR6608-M路由器 快速安装指南-APW102Temperature温度Operating: 0°C to 45°C (32°F to 113°F)Storage: –40°C to +70°C (–40°F to +158°F)工作:0℃~45℃非工作:-40℃~70℃Operating: 5% RH to 95% RH (noncondensing)Storage: 5% RH to 95% RH (noncondensing)工作:5%RH~95%RH(非凝露)非工作:5%RH~95%RH(非凝露)Humidity湿度Phillips screwdriver十字螺丝刀Needle-nose pliers尖嘴钳Wire stripper剥线钳Multimeter万用表Diagonal pliers斜口钳Heat gun热吹风ESD wrist strap防静电腕带Network cable tester测线仪Marker记号笔BOM: 3104A16S