41English6.1.4 Setting Volume LockOperating procedures are as follows:1. Press the corresponding electronic equipment button. The indicator light will comeon for 2 seconds then it goes off; after 3 seconds, the indicator light will come onagain, showing that the setting mode has been entered.2. While holding the electronic equipment button, press VOL+ twice consecutively toassign volume lock to that electronic equipment (meaning the volume buttons willonly transmit code values to the assigned electronic equipment even under otherelectronic equipment modes). The indicator light then goes off and setting mode isexited.3. While holding the electronic equipment button, press VOL- twice consecutively tocancel volume lock under current mode (for example, if volume lock was set underTV mode and you wish to transmit code values under current DVD mode, justperform this unlock operation, while those electronic equipment modes not operatedstill have volume locked up). The indicator light then goes off and setting mode isexited.4. During the setting process, releasing the electronic equipment button exits thesetting mode immediately without changing the status prior to setting.5. Buttons other than VOL+/VOL- are not functional during search. Volume buttonsinclude VOL+, VOL- and MUTE.6.1.5 Setting Channel LockOperating procedures are as follows:1. Press the corresponding electronic equipment button. The indicator light will comeon for 2 seconds then it goes off; after 3 seconds, the indicator light will come onagain, showing that the setting mode has been entered.2. While holding the electronic equipment button, press CH+ twice consecutively toassign channel lock to that electronic equipment (meaning the channel buttons willonly transmit code values to the assigned electronic equipment even under otherelectronic equipment modes). The indicator light then goes off and setting mode isexited.3. While holding the electronic equipment button, press CH- twice consecutively tocancel channel lock under current mode (for example, if channel lock was set underTV mode and you wish to transmit code values under current CABLE mode, just