52Standard Operations1. In the result display, press Options>More>Chemical Form.A list of available evaluation forms appears.2. Select the required chemical form and press OK to confirm.Note: The selected chemical form is displayed, but does not becomethe default. To change the default, see section 5.5.3.1.5.5.3.1 Change of the default setting of the chemical form1. Insert the blank or sample cuvette/vial (depending on theworking procedure) into the cell compartment and close the cellcompartment.2. In the result display, press Options>More>Chemical Form.3. A list of available evaluation forms appear. Select the newdefault setting.4. Press Save as Default.The current result and all further measurements will be displayed inthe new chemical form.5.5.4 Basic test-specific and sample-specific data settingsPress Options to change test or sample specific settings.Table 5 Barcode program optionsOptions DescriptionMore For further OptionsStore Off/On With the Store On setting, all measurement data are stored automatically. With the Store Offsetting, no measurement data are stored.Abs % Trans To switch to % transmittance or absorbance readings
