Hach Lange RTC105 N-Module User Manual
Also see for RTC105: Basic user manual
                                              |
27Parameterization and operation4. The selected sensor is shown in the sensor list.Press ADD (Figure 4, item 3) to open the selection list again.5. Select the second sensor for the RTC module and confirmby pressing ENTER below the selection list.Note: Previously selected sensors are shown in gray.The selected sensors are shown in the sensor list.6. To sort the sensors in the order specified for the RTCmodule, press the sensor and use the arrow keys to move it(Figure 4, item 5).Press DELETE (Figure 4, item 4) to remove an incorrectsensor from the sensor list again.7. Press ENTER (Figure 4, item 1) to confirm the list once it isfinished. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine