Hach RTC101 Basic User Manual

Also see for RTC105: User manual

Contents

Hach RTC101 Basic User Manual Manual pdf 5 page image

Supporting test records reside with the manufacturer.This Class A digital apparatus meets all requirements of the Canadian Interference-CausingEquipment Regulations.Cet appareil numérique de classe A répond à toutes les exigences de la réglementation canadiennesur les équipements provoquant des interférences.FCC Part 15, Class "A" LimitsSupporting test records reside with the manufacturer. The device complies with Part 15 of the FCCRules. Operation is subject to the following conditions:1. The equipment may not cause harmful interference.2. The equipment must accept any interference received, including interference that may causeundesired operation.Changes or modifications to this equipment not expressly approved by the party responsible forcompliance could void the user's authority to operate the equipment. This equipment has been testedand found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules.These limits are designed to provide reasonable protection against harmful interference when theequipment is operated in a commercial environment. This equipment generates, uses and canradiate radio frequency energy and, if not installed and used in accordance with the instructionmanual, may cause harmful interference to radio communications. Operation of this equipment in aresidential area is likely to cause harmful interference, in which case the user will be required tocorrect the interference at their expense. The following techniques can be used to reduceinterference problems:1. Disconnect the equipment from its power source to verify that it is or is not the source of theinterference.2. If the equipment is connected to the same outlet as the device experiencing interference, connectthe equipment to a different outlet.3. Move the equipment away from the device receiving the interference.4. Reposition the receiving antenna for the device receiving the interference.5. Try combinations of the above.Product overviewN O T I C EThe use of a Real-Time Controller (RTC) module does not replace system maintenance. Make sure that allinstruments connected to the RTC open/closed-loop controller are always in good condition. Regularmaintenance is necessary to make sure that the instruments supply correct, reliable measurement values. Referto the user documentation of each instrument.RTC modules are general application control units that makes some processes better in treatmentplants. RTC modules are available as 1-channel, 2-channel or multi-channel systems.Multi-channel RTC modules are usually operated on industrial PCs (IPC) and all input/output signalsare transferred through the sc1000 controller. Refer to the sc1000 documentation. Refer to thedocumentation supplied with the hardware.Product componentsN O T I C EThe combination of pre-assembled components supplied by the manufacturer does not show an independently-functioning unit. In accordance with EU guidelines, this combination of pre-assembled components is not suppliedwith a CE mark, and there is no EU declaration of conformity for the combination. However, the conformity of thecombination of components with the guidelines can be proved through technical measurements.Make sure that all components have been received. If any items are missing or damaged, contact themanufacturer or a sales representative immediately.Each RTC module is supplied with a:• SUB-D connector (9 pin)English 5