105Appendix D Programming WorksheetBasic Programming Guidelines• Go through all Setup menu items and configure each.• Next, review the items in the Advanced Options menu and configure any itemsneeded.• Always check Data Logging and Totalizer Setup. Data logging channels must beenabled if you want to record the data in memory. Also, the totalizer should beconfigured with an acceptable scaling factor for the flow rate at each site.• Go to the options menu and set the time and date if not already set.• When finished, press the RUN/STOP key to start the program.• Photocopy the following worksheets to record your program settings at each site foreasy reference.SETUP MENU From the Main Menu, select SETUP, MODIFY ALL ITEMS.1. Select FLOW unit of measure (gps, gpm, gph, lps, lpm, lph, mgd, afd, cfs, cfm, cfh,cfd, cms, cmm, cmh, cmd): __________2. Select LEVEL unit of measure (cm, m, in., ft): __________3. Select a PRIMARY DEVICE:___________Flume: Type______________, Size__________________Weir: Type______________, Size__________________Nozzle: Type______________, Size__________________Manning Formula:Slope________, Roughness___________, Pipe Diameter___________Power Equation:K 1 =_________, n1 =_________, K2 =_________, n 3 =_________Head vs. Flow4. Enable PROGRAM LOCK password: (Y / N) (Password is always 9500)5. Enable SAMPLER PACING: (Y / N):Flow interval:__________, Flow unit of measure:___________6. Enter a SITE IDENTIFICATION:_________________________________7. Enter unit of measure for TOTAL FLOW (acre-feet, cubic feet, gallons, liters, cubicmeters):__________Name: Date: Serial No.: ID No.:Program Software Versions for:Flow Meter: DTU: InSight Flo-Center
