Hafco MetalMaster CS-350V Instruction Manual

Contents

Hafco MetalMaster CS-350V Instruction Manual Manual pdf 6 page image

66 GGEETTTTIINNGG SSTTAARRTTEEDD Make sure that the electrical supply and the machine’s voltage are the same. Refer tothe identification plate on the motor for the correct voltage. Use a good quality grounded electrical system. All internal and/or internal operations, maintenance or repairs, must be performed in awell-lit area or where there is sufficient light from extra sources so as to avoid the risk ofeven slight accidents.6.1 Minimum Requirements for Housing the MachineThe Main voltage and frequency complying with the requirements for the machine’s motor.Environment temperature from –10°C to +50°C.Relative humidity not over 90%.6.2 Anchoring the Machine Position the machine on a firm and level concrete floor. Maintain a minimum distance of 800mm from the wall torear of the machine. Anchor the machine to the ground, as shown in thediagram, using screws and expansion plugs or sunkentie rods that connect through holes in the base of thestand. Ensuring that it is sitting level.6.3 Assembly and SetupPositioning the machinePlease follow the instruction bellow when unpacking the machinefrom the package. Take out the accessory box from the rear for assemblingsome parts later. Take out the machine from the package to the intendedworking location by hoisting with the belts. The load capacityis about 300kgs at point E. Method one: Use a sling. Carefully wrap the sling (E) aroundthe collar of the moveable jaw and motor mount. Method two: Using lift rings. Attach lifting rings to three pointson the base of the machine. Attach a three-point sling withgrab or sling hooks to the lift rings.Initial Cleaning Machine is shipped with rustproof oil coating. Clean the rustproof oil coating from all exposed metal surface. Then applyoil / grease. The stand of the cold saw has four mounting holes, two holeson each side of the stand( ). The cold saw should be keptlevel and rest solidly on the floor. Please refer to the anchoring section above. When securingthe stand to the floor, apply even torque to the fasteners toprevent distortion of the stand.EE12Page 6Instruction Manual for CS-350V (S830)03/12/2014