Hague Quality Water 700MM Installation And Service Manual

Contents

Hague Quality Water 700MM Installation And Service Manual Manual pdf 13 page image

11Installation And Start-Up ProceduresEach water conditioning appliance includes water test strips and 8' of drain line.CAUTION: Be sure the controller is firmly “locked” onto the drive end cap assembly. The four tabson top of the drive end cap will allow the clips on the bottom of the controller case to lock onto theend cap tabs. (See detail diagram on page 16. Fig. 11.)1. Placement: Place your appliance in desired location. Turn off electricity and water supply towater heater. Make sure inlet/outlet and drain connections meet the applicable local codes. Checkarrows on valve to be sure water flows in proper direction. See figures 1, 2, & 3.CAUTION: DO NOT PLUMB APPLIANCE IN BACKWARD. See page 62. Drain Line: must be a minimum of 1/2"-5/8” I.D. tubing and should make the shortest run to asuitable drain. The drain line may be elevated up to 8 feet from the discharge on the appliance aslong as the water pressure in your appliance is 40 psi or more. If drain line is 25' or longer, increasedrain line to 5/8" I.D. Also, the end of the drain line must be equal in height or lower than the controlvalve. See figure 1.3. Flushing: Before placing your appliance in service, it is very important to flush the cold waterlines of any debris. Turn on water supply, open the nearest cold water tap and let the water run for 2to 3 minutes or until the water flows clear. Then put the by-pass in the Service position. See figures4 through 6.4. Check Leaks. Close faucet and check for leaks. If leaks are found, turn off main water supplyand open the nearest cold water faucet to depressurize lines. Close faucet to eliminate siphoningaction. Repair leaks. Turn on water supply and electricity to water heater. Place the bypass valvein the Service position. See figures 4 and 6.5. Connect Overflow Line. The overflow line must end at a drain that is at least 3" lower than thebottom of the overflow fitting. It is a gravity line and cannot be run overhead. See figure 7.6. Complete The Installation. Open a cold water tap and allow the appliance to flush for 20 minutesor until approximately 72 gallons has passed through the appliance per NSF requirements.7. Plug In Transformer. See figure 8.