Hague Quality Water MAXIMIZER 97 Series Owner's Manual & Installation Manual

Hague Quality Water MAXIMIZER 97 Series Owner's Manual & Installation Manual Manual pdf 27 page image

OR-05/18/15 Maximizer® 97 Owner’s Manual 27Quality Water International ®Assembly and PartsDrive End CapPart # Description Qty. Note8 93583 Drive End Cap 1Seals the two openings on the main control valve. The largerdiameter opening is sealed with an O-Ring used as an axial or “face”seal. The O-Ring sits in a groove in the end cap. This groove mustbe free of defects such as pits or scratches and also free of debris.The smaller diameter seal is accomplished with an O-Ring used asa radial seal. The O-Ring should be placed on the male boss on theend cap. When assembling the end cap to the main control valve,care should be taken to make sure the small O-Ring is aligned withthe opening in the main control valve and that the largeO-Ring stays in the groove in the end cap. If misaligned, the O-Ringscan become pinched and leak.9 54202 Piston Slide 1 The slide should move freely inside the end cap housing.10 90818 Screw 411 93699R-JG Brine ValveHousing Assembly 1Attaches to the drive end cap with two 3/4-inch self-tapping screwsand has one O-Ring seal. The O-Ring is used as axial or “face” seal.The O-Ring sits in a groove in the brine valve housing. The grooveand the face seal must be free of defects such as pits and scratchesor debris.12 90821 O-Ring 113 54502KIT Magnet DiskAssembly 114 53511 Brine PistonAssembly15 90828 O-Ring 116 90819 O-Ring 117 53322Drive PistonAssembly(includes 93839 -Drain Gasket)1The drive piston attaches to the piston slide by placing the “slot”of the piston onto the matching flat of the slide. To remove piston,rotate piston 90° counterclockwise. To replace piston, rotate 90°clockwise until you hear an audible “click.” (see figure 10 below)18 93839 Drain Gasket 1DimpleAlign FlatsPosition Piston Assembly (53322) Vertical Slide Piston Assembly Onto Piston Slide.Push Toward End Cap to Stop.Rotate The Piston Assembly 90 DegreesClockwise Until You Hear An Audible ClickAs It Snaps Into Place.90°Figure 10: Piston Slide Assembly