MaintenanceThe inlet grill is supported by its topplate at the right side.3.Take the VC layer + Bacteria-killingmedium setsTake out Take the VC layer or the Bacteria-killingmedium sets from the filter. Push the bottom frameof AIP layer, and push up the handle at the sametime in order take out the AIP layer board in turns.4. The installation of AIP layer,VC layer + Bacteria-killing medium sets(must be installed)Put down the inlet grill’s top plate, and close the inlet grill.(AIP board)****In order to keep the AIP layer having a highly work effect ,it should be cleaned regularly oraperiodically just according to the working environment.1. Turn off the A/C electricity supply and make sure that AIP layer is not working.Then clean theAIP layer after turning off it five minutes later.2. Please brush off the dust on AIP board,then steep it into cleaning agent water and wash it.3. After cleaning AIP board pleas put it on a dry place until it is totally dry.4. Ensure AIP board is dry enough then install it in the its position along the slide way .Make sure it is as before and could work well.Note:the green aspect of the bacteria-killingmedium air purifying filter will face outside, thewhite aspect will face to the machine. Theyellow aspect of the VC layer will face outside,the white aspect will face to the machine.Common sense:1.Open the lnlet Grille2.Detach the standard air filter5.Close the Inlet Grilleinlet grill’s top plateThe installation and cleanout AIP layer, VC layer + Bacteria-killing medium setsPush up the filter's center tab slightlyuntil it is released from the stopper, andremove the filter downward.In the use, please note to clean the filter frequently (take off the back suction cleaner or lightly pat it)to avoid the operating effect is lowered due to the dust covering the filter. AIP layer and bacteria-killingmedium filter is strictly prohibited from being cleaned by water.AIP(air ionization purify)(bottom frame)The the bacteria-killing medium filter not in use should be stored in shade, cool and dry place.Please don't expose it to the sunlight for a long time otherwise the degerming performance will drop.The AIP layer will be replaced in fixed time. In normal family, it will be replaced every 6 months.22