Emergency Operation:Carry out this operation only when the remote controller is defective or lost.When the emergency operation switch is pressed, a" Pi "sound starts once, whichmeans the start of this operation.In this operation, it is not possible to change thesettings of temperature and air flow speed, it isalso impossible to do an operation by the timer.Follow the requirements below.Roomtemperature DesignatedtemperatureTimermode Air flowspeed OperationmodeMore than 23oCLess than 23o C26o C CONTINUOUSCONTINUOUSAUTOAUTOCOOLIf an air conditioner is a model for both cooling and heating.Cooling when the room temperature at the start of operation is above 23o C.12Emergency operation and test operationOperationHeating when the room temperature at the start of operation is below 23oCtemperature is less 16 oC, do not use it in the normalTest operation:Use this switch in the test operation when the roomoperation.operation starts with the air flow speed setting "Hi".Continue to press the test operation switch for morethan 5 seconds. After you hear the "Pi" sound twice,release your finger from the switch, the coolingRemoval of the restriction of emergency or test operation:Press once more the emergency operation switch, or manipulate through the remotecontroller, a "Pi" sound causes the restriction of emergency or test operation to beremoved.When the remote controller is manipulated for the removal, then the selected operationby the remote controller.HEAT23 o CPiPi Pi