Haier 10552537 Operation Manual

Haier 10552537 Operation Manual Manual pdf 11 page image

Note:(1)when the unit is operatinghealth or sterilize function," "displayed on the display boardand " " is displayed on thedi splay board in the freshfunction.Operation102.Health anion functionAir conditioner starts health anion function operation.For twice press, disappears,the operation stops.3.UV light degerming functionPress STERILIZE button ," "and " "displayed on the remotecontroller and the air conditioning starts the UV light degermingfunction." ": For timing operation of UV light degerming function andautomatically canceled after 30 minutes' operation." ": For the long-time running of UV light degerming function.No display: For UV light degerming function not starting.4.Change-for-fresh-air functionPress FRESH button , " "displayed on the remotecontroller and the change-for-fresh-air function operation begins.For twice press , the display " "disappears and thechange-for-fresh-air function operation is canceledBRIEF INTRODUCTION TO HEALTH ANION FUCTIONUV light emitted by the UV light device of the indoor unit catalyticallyactivates the nano TiO2 on the multi-lights touching intermediary,and the degerming effect is highly efficient and lasting.Note: when the function is running, don't open the inlet grille.About UV light degerming function1.After the change-for-fresh-air function is initiated, the outside air canenter the indoors through the change-for-fresh-air tube therebykeeping the indoor air fresh.About change-for-fresh-air functionHealth function includes health anion function, UV lightdegerming function and change-for-fresh-air function.The anion generator in the air conditioner can generate a lot ofanion effectively balance the quantity of position and anion in theair and also to kill bacteria and speed up the dust sediment inthe room and finally clean the air in the room.When the fan in the indoor unit does not work, the health lamplights up, but the anion generator does not release anion.When indoor fan motor is running, it has healthyprocess function. (It's available under any mode)Press ON/OFF on the remote controller, unit starts.Press HEALTH button. For each press, is displayed.1.Unit start2.Setting the change-for-fresh-air function under the shutdown status:Under shutdown status, press the new wind key and the remotecontroller displays the on status of air flow, low wind, and change-for-fresh-air functions, and now can set the timing open, timingclose and time control switch. Press on-off button to cancel thechange-for-fresh-air function.HEALTH operation(2) The buttons and the functions ofFRESH and STERILIZE are only forthe units of HSU-09HV03/R2(SBD)and HSU-12HV03/R2(SBD).(3) The buttons and the functions ofPower/Soft are only for the units ofHSU-07$09$12$18HV03/R2(BD).(4) When using the HEALTH/STERILIZEfunction, the backlight is green;When using the FRESH function,the backlight is yellowish green;If using the HEALTH/STERILIZE andFRESH functions at the same time,the color is the last one.Remote controllerFRESHSTERILIZE