46Domestic air conditioner62U14CS1ERA-SM IntroductionIndoor Unit InstallaionDriver● Torque wrench●(17mm,22mm,26mm)Nipper●Reamer●Hacksaw● Pipe cutter●Gas leakage detector or●soap-and-water solutionHole core drill● Flaring tool●Spanner(17,19 and 26mm)● Knife●Measuring tape●Necessary Tools for Installation Power SourceBefore inserting power into receptacle, check the voltagewithout fail.The power supply is the same as the corresponding nameplate.Install an exclusive branch circuit of the power.A receptacle shall be set up in a distance where the power cablecan be reached.Do not extend the cable by cutting it.Selection of Installation PlacePlace, robust not causing vibration, where the body can besupported sufficiently.●Place, not affected by heat or steam generated in the vicinity,where inlet and outlet of the unit are not disturbed.●Place, possible to drain easily, where piping can be conne-cted with the outdoor unit.●Place, where cold air can be spread in a room entirely.●Place, nearby a power receptacle, with enough space around.●Place where the distance of more than lm from televisions,radios, wireless apparatuses and fluorescent lamps can beleft.●In the case of fixing the remote controller on a wall, placewhere the indoor unit can receive signals when the fluore-scent●lamps in the room are lightened.●●●The distance between the indoor unit and the floor should be more than 2m.The models adopt HFC free refrigerant R410Amore than10cmmore than 15 cmmore than 10cmArrangement of pipingdirectionsRear leftLeft RearrightRightBelowAttention must be paid tothe rising up of drain hoseRemote controller (1)R-03 dry battery (2)Mounting plate (1)Drain hose (1)Ø4X25 Screw (4)Plastic cap (4)Accessory PartsFOR 07K 09K 12KFOR 18KFOR 24KSelection of PipeDrawing for the installation of indoor units●Air purifying filter(Optional) (1)Please be subject to the actual product purchased,the above picture is just for your reference.