Haier AB142ACBAC Operation Manual

Haier AB142ACBAC Operation Manual Manual pdf 27 page image

284. Installation of Ornament PanelInstall ornament panel on indoor unit(1) Check whether indoor unit is horizontal with leveler or polythene pipe filled with water , andcheck that the dimension of the ceiling opening is correct. Take off the lever gauge before installthe ornament panel.(2)Fasten the screws to make the height difference between the two sides of indoor unit less than5mm.(3) First fix it with screws temporally.(4) Fasten the two temporally fixing screws and other two, and tighten the four screws.(5) Connect the wires of synchro-motor.(6) Connect the wire of signal.(7) If no response of remote controller,check whether the wiring is correct,restart remote controller10 seconds after shut off power supply.Limits of panel board installation(1)Install the panel board in the direction shown inthe figure.(2)The incorrect direction will result in water leakage,meanwhile swing and signal receiving are displayedthat cannot be connected.Display windowDrain hosePipePipeLouver motorLiquid inlet pipeGas outlet pipeDrain hoseInstallation Procedure