Haier AB142ACBBA Operation Manual

Haier AB142ACBBA Operation Manual Manual pdf 28 page image

26(3) Install a suspending boltTo support the unit weight ,anchor bolt should be used in the case ofalready exists ceiling. Fow new ceiling, use flush-in type bolt, built-intype bolt or parts pretared in the field.Before going on installing, adjust space to ceiling.Installation of indoor unitIn case of no ceilingInstall unit temporallyPut suspending bracket on the suspending bolt to hang the unit up. Be sure to use nut andwasher at both end of the breaket to secure firmly.After installation on the ceiling(1) Adjust unit to its right position (Refer to preparation for installation-(1))(2)Check that unit is horzontal.Put suspending bracket on the suspending bolt to hang theunit up.Be sure to use nut and washer at both end of thebracket to secure it firmly.Water pump and floating switch is installed inside indoor unit,check four corners of the unit forits lever using horizontal comparator or PVC tube with water.(If unit is tilting against the directionof water drainage,problem may occur on floating water leakage.)In the case of ceiling already exists(1)Install unit temporally(2)Adjust the height and position of the unit.(3)Proceed with procedure (4) of ì In the case of no ceiling ìNut (Prepare in feild)Washer (Prepared in feild)Suspending boltsFasten (double nuts)InsertWasher fixing pad(prepared in feild)[ secure the washer firmly]leveler Polythene pipe 50*150mmCeilingRoofAnchor boltLong nut or threadSuspending bilt M10Note: All the above mentioned parts shall be prepared in feild,the diameter of suspending bolt is M10Installation Procedures