Haier AB142ACEAA Operation And Installation Manual

Also see for AB142ACBEA: Service manual Manuel d'utilisation Service manual

Haier AB142ACEAA Operation And Installation Manual Manual pdf 28 page image

26As for outdoor unit circuit, please see Installation Manual of outdoor unit.Note: All electric wires have their own poles, poles must match that on terminal block.9. INSTALLATION OF ORNAMENT PANEL1. Prepare ornament panel Handling of ornament panelOrnament panel shall not be placed face down or against wall, neitheron an uneven object.Don' t bend carelessly the swing flap, or, problem may occur.(1) Remove air inlet grill from ornament panel *Push in the bar on inlet grill and lift it up. (Refer to Fig. 1)Lift it up for about 45 degree and remove it from ornament. Tear off adhesivetape fixing air filter on the back of the air inlet grill. (Refer to Fig. 2)Be sure to show customers Operation Manual and guide them how to operate unitcorrectly. Before installation. read also the Installation Manual of indoor unit.With this ornament , 2 or 3 air flow direction is not available.Suitable height is 3 m.2(2) Remove cover plate at cornerTear off the adhesive tape, and slide it off. (Refer to Fig. 3)8. WIRING EXAMPLECautions for the installationAccessory Pad89 Bar Fig. 17. WIRINGAll supplied parts. materials and wiring operation must in appliance withlocal code and regulations.Use copper wire only.When make wiring, please refer to wiring diagram also.All wiring work must be done by qualified electricians.A circuit breaker must be installed, which can cut power supply to all system.See Installation Manual of outdoor unit for specifications of wires, circuit breaker, switches and wiring etc.Connecting of unitRemove cover of switch box (1) , drag wires into rubber tube A, then, after proper wiring with other wires,tighten clamp A. Connect wires of correct pole to the terminal block inside.Wind seal 12 around wires. (Be sure to do that, or, dew may occur).Upon connecting, replace control box cover (1) and (2).Obscrve the following when connecting power supplyterminal block:Don't connect wires of different specifications to the sameterminal block.(Loose wire may cause overheating of circuit)Connect wires of same specifications as shown in right Fig.Connect wires of thesame specificationsat two sides.Don't connect wires ofthe same specificationsat one side.Don't connect wiresof the differentspecifications.<<WARNING>>7Pad45Fig. 2Adbesive tapeTerminal blockCover of control box(1)Rubber tube AGrounding leadCover of control box(2)OutInField wiringAttach seal padDon't fail to seal it, or water may come in.Rubber tube Note: Have it sealed, leaving no space.Seal pad (small size )(Wind around wire)*121SlideFig. 3Installation Procedure

/ 31

Related manuals for Haier AB142ACBEA