REMOTE CONTROLLER OPERATIONRemote controller's operationWhen in use, put the signal transmission head directly to the receiver hole on the indoor unit.The distance between the signal transmission head and the receiver hole should be within 7mwithout any obstacle as well.Don't throw the controller, prevent it from being damaged.When electronic-started type fluorescent lamp or change-over type fluorescent lamp or wirelesstelephone is installed in the room, the receiver is apt to be disturbed in receiving the signals sothe distance to the indoor unit should be shorter.Loading of the batteryLoad the batteries as illustrated.2R-03 batteries, resetting key (cylinder)Remove the battery cover :Slightly press " " and push down the cover.Load the battery :Be sure that the loading is in line with the " + " / " - " pole request asillustrated.Put on the cover againConfirmation indicator :In disorderation, reload the batteries or load the new batteriesafter 5mins.Note :Use two new same-typed batteries when loading.If the remote controller can't run normally or doesn't work at all,use a sharp pointed item to press the reset key.Hint : Remove the batteries in case unit won't be in usage for a long period.If there is any display after taking-out just need to press reset key.TEMPSWING FANONOFFMODESLEEPSETCLOCKTIMERLOCK RESETAMREMOTE CONTROLLER FUNCTIONS