Haier AE092FCAKA Instruction Manual

Also see for AE072FCAKA: Service manual Instruction manual Operation manual Operation & installation manual

Contents

514.Network control displayUsed to adjust thetime of timer andclockWhen the wirecontroller appearsabnormal condition,use a sharp-pointedarticle to press thisbutton to make thewire controllerresume normalAfter cleaning theair inlet, press thisbutton, the unitcan start to operate12.Humidifying state displayUsed to turn on/off unit1.ON/OFF button6.Air filter cleaning display*7.Super/Soft operation display13.Sleep state display2.Temperature display24.Time Adjustingbutton23.Sleep buttonUsed to set SleepstateWhen there is too much dustcollected on the air inlet, thewire controller will showthis display to remind theuser to clean the air inlet.After cleaning and installation,just press the air filter reset button.8.Fan speed display9.Auto Swing display11.Fresh air state display25.Reset button26.Air Filter Resetbutton27.Timer buttonUsed to set themode of timer28.Lock state display4.Timer ON/OFF display3.Clock display17.Operation mode button5.Humidity display22.Setting buttonUsed to confirmthe time of timerand clock15.Working mode display21.Clock buttonUsed to calibrate the time oftimer and clock16.Electric heating displayUsed to set working mode:Auto, Cooling, Dehumidifying,Heating, Fan18.Fan speed buttonUsed to set fan speed: LowFan, Med Fan, High Fan, Auto20.Temperature Setting buttonSUR12345678911121314 15 16 17 18202122232425262728AUTO10.Health state display Used to set temperature,temperature range: 16 C~30 C101919.Swing buttonUsed to set Auto Swing orFixed air sending directionCalibration of clockWhen turning on the unit for the first time, the clock should be calibrated. The methodof calibration is:1.Press ìClockî button, the Clock display ìAMî ìPMî will flash.2.Press or to adjust time. For each press, the time will increase or decrease 1*minute. If depressing the button, the time will increase or decrease rapidly.3.After confirming the time, press ìSetî button, ìAMî or ìPMî will stop flashing,theclock will begin to work.Note:1.This model does not have the following relateddisplay and function2.The outdoor unit no oxygen-bar function or no negative ionunit no healthl function display.AutoLow Fan Med Fan High Fan AutoWorkingmodeAutooperationCoolingoperationDehumidifyingoperationHeatingoperationFanoperationWirecontrollerMODE FAN SWINGTEMPCLOCK SETTIMER SLEEPRESETFILTER RESETON/OFFSETHEALTH 29305 6 7 9191011 12 14 16 2629.HealthUsed to control thegenerating oxygenfunction and negativeion-function30.Remote control windowUsed to receive theremote control signalD